Epson SC-R5000 Series - How to Install

M
Remove the left side connector in the same way,
and place it on the holder.
N
Open the protective case of the replacement Print
Head, and place it so the inside of the lid is facing
upwards.
Later, you will place the used Print Head that you
removed on the upside down lid.
O
Use both hands to lift the Print Head straight up
and remove it.
Hold the Print Head correctly.
U “Correctly Holding the Print Head” on
page 11
P
Place the used Print Head that you removed on
the lid of the protective case.
How to Install
You can check the procedure in a video on YouTube.
Epson Video Manuals
Hold the Print Head correctly.
U “Correctly Holding the Print Head” on page 11
SC-R5000 Series/SC-R5000L Series User Self Repair Guide
Replacing and Adjusting the Print Head
15