c
Important:
❏ Do not apply excessive force, such as
pulling them too hard, to the ink tubes
connected to the Ink Damper Unit. If they
become deformed, a malfunction may
occur.
❏ Do not touch the bottom of the Ink
Damper Unit. There is a risk of deforming
the ink supply ports.
K
Use your fingers to turn the connector fixing
screws (4 pc) counterclockwise to loosen them.
If you cannot loosen the screws with your fingers,
use a coin or flathead screwdriver to loosen them.
You can loosen the screws, but they cannot be
removed from the connector.
L
Lift the right side connector straight up to
remove it, and place it on the holder.
c
Important:
Press down on the Print Head as you remove
the connector so the connector's pins are not
deformed or damaged.
SC-R5000 Series/SC-R5000L Series User Self Repair Guide
Replacing and Adjusting the Print Head
14
To Next Page
Loading...
