G
Install the new cutter.
Insert the cutter so that the pin on the printer
matches up with the hole on the cutter. Use a
cross-head screwdriver to tighten down the
screw to hold the cutter in place.
c
Important:
Screw up the cutter firmly, otherwise the cut
position may be slightly shifted or skewed.
H
After replacing the cutter, press the Z button.
The cutter will return to its original position.
Ready is displayed in the control panel when the
process is complete.
SC-T7200 Series/SC-T5200 Series/SC-T3200 Series/SC-T7200D Series/SC-T5200D Series User's Guide
Maintenance
173
To Next Page
Loading...
Need help?
General
