Epson Stylus CX7300 - Page 86

86
Problems and Solutions
Check these sections for solutions to problems you may have using the Epson Stylus CX7300
Series:
Setup Problems
Copying Problems
Paper Problems
Problems Printing From a Computer
Page Layout and Content Problems
Print Quality Problems (quality is correct on screen)
Image Quality Problems (quality problem appears on screen)
If none of the solutions here solve your problem, contact Epson for help.
See also:
Problem-solving Tools
Re-installing Software
Setup Problems
Noise After Ink Installation
Software Installation Problems
Noise After Ink Installation
• The first time you install ink cartridges, the Epson Stylus CX7300 Series must charge its print
head for 2 minutes or so. Wait until charging finishes (the Encender (On) light stops
flashing) before you turn off the Epson Stylus CX7300 Series, or it may charge improperly
and use excess ink the next time you turn it on.
If the printer stops moving or making noise, but the Encender (On) light is still flashing
after 5 minutes, turn off the Epson Stylus CX7300 Series. If the light is still flashing when you
turn it back on, contact Epson
.
Scanner
Ink cartridge holder
(in home position)