Epson Stylus Photo 750 - Page 75

EPSON Stylus Photo 750 Revision A
Disassembly and Assembly Disassembly 70
4.2.5.9 PE Sensor Assembly Removal
1. Remove the upper housing.(See “Housing Removal” on page -54)
2. Release 2 hooks from the frame surface and remove “PE Sensor
Assembly” by sliding it.
Figure 4-21. PE Sensor Assembly Removal
CHECK
PO INT
When installing the PE Sensor Assembly, be sure
that the sensor lever is correctly inserted into a hole
of “Paper Guide Assembly”.
LEVER, PE
BOARD ASSY., PE
HOLDER, PE
To fram e
R elease these hooks to
rem ove the PE S ensor Assem bly
From the back side of
the m echanism
T o rs io n S p rin g ,0 .2 2