EPSON Stylus Photo 750 Revision A
Disassembly and Assembly Disassembly 69
Figure 4-20. Carriage Assembly Removal
CHECK
PO INT
When installing the spring washer, convex side
should be facing to the “Bush, Parallel Adjust,
Right”. Be careful not to install in wrong direction.
ADJUSTM ENT
REQUIRED
Perform following adjustments, after replacing or
removing “Carriage Assembly”.
„
Paper Gap Adjustment (See “Paper Gap
Adjustment” on page -78)
„
Head Angular Adjustment (See “Head Angular
Adjustment” on page -84)
„
Bi-D Adjustment (See “Bi-D Adjustment” on
page -86)
C arriage A ssem bly
BUSH, PARALLEL ADJUST, LEFT
BUSH, PARALLEL ADJUST, RIGHT
LEVER, PG, SUB
Spring W asher
(C onvex side m ust be facing the bush)
SHAFT, CR, G UIDE
To Next Page
Loading...
