Epson Stylus Photo 750 - Page 90

EPSON Stylus Photo 750 Revision A
Adjustment Adjustment by Adjustment Program 85
5. Refer to the printing pattern, and adjust the head angle by using the
adjustment lever.
Figure 5-5. Lever Operation and Corresponding Change in Pattern
6. Head angular pattern is printed, every time the adjustment lever is
moved.
7. Repeat Step 4 to 6 until the angle becomes normal.
8. After adjustment is completed, press ESC key until the screen goes
back to the adjustment menu.
9. Tighten the screw for fixing the head.
CHECK
PO INT
„
When performing the head angular adjustment,
select “Move the carriage to the head angular
adjustment position” so that the carriage moves to
the center of the printable area. This enables the
adjustment lever to move easily. However, since the
head nozzle may dry out, move it within 5 seconds.
„
In order to make the carriage return to the home
position, select “Return the carriage to the home
position” and press Return key.
T o m o v e th is u p ,
C orrect condition = evenly spaced
m ove the lever to
th e le ft (fro n t).
m o v e th e le v e r to th e
rig h t (re a r).
Adjustm ent Lever
T o m o v e th is d o w n ,
aj11