14 Using EPSON Paper
Loading Paper in the Sheet Feeder
1. Make sure the paper support is open and the extension is raised up.
2. Place your paper against the right edge of the feeder. Make sure the printable (whiter or
glossier) side of the paper is face up. If you are loading multiple sheets, fan the stack of
paper before loading it to prevent paper jams.
Note: Don’t load paper above the arrow mark inside the left edge guide. Some
special papers can be loaded only one sheet at a time. See your online Reference
Guide for details.
3. Slide the left edge guide against the paper. (For letter-size paper, you may not need to
move the edge guide over.)
4. Open the output tray and pull out the extension.
You should also follow these guidelines:
■ Always load the short edge first, even when you’re printing landscape-oriented pictures.
■ When using special papers, check the paper package for additional instructions. Some
papers require using a support sheet included in the package.
Note: Always keep unused paper in the original package and store it flat to
prevent curling.
Pbasics.book Page 14 Tuesday, June 1, 2004 1:31 PM
To Next Page
Loading...
