Epson Stylus Photo R800 - Page 44

EPSON Stylus Photo R800 Revision A
TROUBLESHOOTING Overview 45
At operation Though paper is fed from the
ASF Assy., it stops near the
PE Sensor Lever.
PE Sensor 1. Check that the Connector cable of the PE Sensor is
securely connected to the PE Sensor and Relay Board
Connector (CN3).
1. Connect the Connector cable of the PE
Sensor to the PE Sensor and Relay
Board Connector.
2. Check that the Sensor Holder is mounted to the
Mechanical frame correctly.
2. Install the Sensor Holder correctly.
3. Move the Detection Lever actively by hand in the same
state as when the paper passes, and check that the
Detection Lever is returned to the original position
automatically by the Torsion Spring when released.
(Refer to the above photo.)
3. Change the PE Sensor Holder Unit for a
new one.
4. Using a tester, check that the PE Sensor is normal.
⋅ Paper present : 2.4V or more
⋅ Paper absent : 0.4V or less
4. Change the PE Sensor Holder Unit for a
new one.
Table 3-4. Phenomenon-Based Paper Out Error Check Points
Occurrence
Timing
Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
Relay Board Connector
PE Sensor
Detection Lever
Torsion Spring
Sensor Holder
Download Service Manual And Resetter Printer at http://printer1.blogspot.com