EPSON Stylus Photo R800 Revision A
TROUBLESHOOTING Overview 47
The Paper Switch
was pressed at the
setting of the CD-R
Tray or board paper
The trailing edge of the CD-R
Tray is fed toward the ASF
Assy. up to the Driven Roller
of the Upper Paper Guide,
and is then fed in an attempt
to move it farther, but the
Tray is ejected.
PW Sensor 1. Check that the PW Sensor FFC is placed in the specified
routing positions and does not make contact with any
parts.
1. Place the PW Sensor FFC in the
specified routing positions.
2. Check that the PW Sensor FFC is not disconnected from
the CR Encoder Board and PW Sensor Connectors. (Refer
to the above photo.)
2. Connect the FFC to the CR Encoder
Board and PW Sensor Connectors.
3. Check the PW Sensor or PW Sensor FFC for damage. 3. Change the PW Sensor for a new one.
Table 3-4. Phenomenon-Based Paper Out Error Check Points
Occurrence
Timing
Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
PW Sensor
Connector
FFC
CR Encoder Board
Connector
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
To Next Page
Loading...
