Epson Stylus Photo RX600 - Loading and Setting Film on the Document Table

48 Printing from Film
Loading and Setting Film on the Document Table
c
Caution:
Hold the film at its edges, or else use gloves. Touching the film surface
with bare hands can leave fingerprints or other traces on the film.
Note:
Wipe the inside of the document cover and the document table before scanning
transparencies.
1. Make sure the document cover’s cable is connected to the TPU
interface connector and open the document cover.
2. Remove the reflective document mat gently along the document
cover.
Note:
Make sure to hold the document cover with both hands.