68 Maintenance and Transporting
Aligning the Print Head
If you notice vertical lines are not aligned properly on the nozzle check
result, you may be able to solve this problem by aligning the print head.
Note:
Do not press the y Stop button to cancel printing while printing an alignment
pattern.
1. Make sure that A4 or Letter paper is loaded in the sheet feeder and
press the Setup button.
2. Select Head Alignment.
3. Confirm the messages on the LCD panel, then press the OK button
to start Head alignment.
4. Look at the alignment patterns. Find the pair of vertical lines that is
aligned in pattern #1, and then select the number using the l/r
buttons. Finally, press the OK button to enter your selection.
5. The next pattern number appears. As with pattern #1, find and
register the aligned pairs for the remaining alignment patterns #2
through #4.
6. Press the OK button to finish the head alignment.
After all patterns are set, the print head alignment operation is
completed.
1. Select Head Alignment.
2. Press the OK button.
To Next Page
Loading...
