Epson Stylus Pro 4800 - Replacing the Maintenance Tank

Epson Stylus Pro 4800
8/05 Epson Stylus Pro 4800 - 11
6. When
REPLACE CUTTER is displayed on the LCD, hold
down the side pin as shown and turn the latch to the right.
7. Release the side pin and carefully remove the cutter blade.
WARNING:
The blade is sharp. Be careful when removing it.
8. Insert the new cutter as shown.
9. Push down on the side pin while turning the latch to the
left.
10. Close the top cover when you see a message prompting you
to do so. The cutter moves to the home position.
Replacing the Maintenance Tank
The maintenance tank stores ink that gets flushed from the
system during manual and automatic print head cleaning.
When the tank is almost full, the message
MNT TK NEAR
FULL
appears on the LCD panel. When the tank is completely
full, the printer stops working and
MNT TNK FULL appears
on the LCD.
You can check how much space remains in the maintenance
tank by viewing its indicator on the control panel, shown
below. You can also check its status by printing a nozzle check
sheet (see page 7).
Replacement tanks are available from Epson (part number
C12C890191).
Note:
You can purchase replacement items for your printer from Epson at
(800) 873-7766, or by visiting the Epson Store
SM
at
www.epsonstore.com (U.S. sales only). In Canada, please call
(800) 463-7766 for dealer referral.
Follow these steps to replace the tank:
1. Make sure the printer is not printing or performing any
other operations (
READY or PAPER OUT should appear on
the control panel).
Maintenance tank
indicator (showing
a new tank)