Epson Stylus Pro 4800 - Error Messages

Epson Stylus Pro 4800
4 - Epson Stylus Pro 4800 8/05
Error Messages
When a problem occurs, a message appears on the display and
the lights on the control panel come on or flash.
Message/Light Light Explanation Response
CHANGE PAPER TYPE Paper light on Paper loaded does not match the
source selected.
Press the Paper Source button to select the correct
setting: either (for paper in the tray, or or
for roll paper).
COMMAND ERROR — You’re using the wrong printer driver.
Damaged data was sent to the printer
or the data has an incorrect command.
The installed printer driver is not
correct for the printer.
Press the Pause button and hold it for 3 seconds to
cancel the print job. Make sure you installed the
correct driver for your printer.
Press the Pause button and hold it for 3 seconds to
cancel the print job.
Stop printing, and press the Pause button for 3
seconds. Then make sure that the installed printer
driver is correct for the printer.
DRIVER INK SET SETTING IS
WRONG
MISMATCH ERROR
Note:
These messages alternate.
— The black ink cartridge option does
not match what is selected in the
driver
Non-Epson genuine ink cartridge is
installed.
Stop printing, and then press and hold the Pause
button for 3 seconds. Select the correct black ink
cartridge option in the driver. If you want to continue
printing, press the Pause button.
Press the Pause button for 3 seconds to cancel
printing. If you want to continue printing, press the
Pause button.
FEED SHEET PAPER
FEED SHEET PAPER
MANUALLY
— Cut sheet needs to be loaded
manually.
Load the sheet in the manual feed slot. .
FORBIDDEN MEDIA FROM P.
TRAY
— Cut sheet needs to be loaded
manually.
Load the sheet in the manual feed slot.
INK LOW B Ink light flashing Ink cartridge(s) are nearly empty
(printing continues).
Make sure you have replacement cartridges available.
INK OUT B Ink light on Ink cartridge(s) are empty (printing
stops).
Replace the ink cartridge(s) indicated on the LCD
panel.
INVALID INK CRTG B Ink light on You tried to install the wrong ink
cartridge.
If you are installing ink cartridges for the first time, you
must install the cartridges that came with your printer.
If you are replacing ink cartridges, check the package
and product code. You must use the ink cartridges
designed for your printer. Other cartridges will not
work.
LOAD PAPER
Paper light on Paper lever is in the released position
while loading paper.
After you finish loading paper, pull the paper lever all
the way forward, to the secured position.
LOAD ROLL PAPER
LOAD SHEET PAPER IN P.
TRAY
Paper light on Paper source setting in printer driver
is different from control panel.
Make sure the right paper is loaded and the paper
source setting is the same on the control panel and
printer driver.
LOWER INK LEVERS
LOWER L (or R) INK LVR
— One or both ink levers are raised. Pull the lever or levers down to lock the ink cartridges.
MNT REQ. — A printer part will need to be replaced
soon.
Note the code number and contact Epson.
MNT TK NEAR FULL — The maintenance tank is almost full. Make sure you have a replacement maintenance tank.
MNT TNK FULL B Ink light on The maintenance tank is full. Replace the maintenance tank.