Epson Stylus Pro 4800
8/05 Epson Stylus Pro 4800 - 5
NO BORDERLESS WITH THIS
SIZE
RELOAD PAPER
Note:
These messages alternate.
— Borderless setting selected for A2-
size sheets (11.7 × 16.5)
Change the setting in the printer driver, or load
different-size paper.
NO INK CRTG B Ink light on Ink cartridge(s) not installed or ink
lever raised.
Install ink cartridges or lower the ink lever.
NO MNT TNK — The maintenance tank is not installed. Make sure the maintenance tank is fully inserted.
NOT STRAIGHT RELOAD Paper light on Cut sheet paper is not loaded straight. Load the paper correctly.
NOZZLES STILL CLOGGED — Head cleaning did not clear the
nozzles.
Run the head cleaning utility again. If the nozzles are
still clogged, contact Epson.
OPTION I/F ERROR — Wrong interface card installed. Turn off the printer and remove the card. See the
documentation that came with the card.
PAPER NOT CUT Paper light
flashing
Roll paper was not cut correctly.
The cutter may be blunt or incorrectly
installed.
Open the top cover and remove the uncut paper.
Reload paper if necessary.
Reinstall or replace the cutter blade if necessary.
PAPER NOT STRAIGHT Paper light
flashing
Paper slipped and fed into the printer
at an angle.
Reload paper, making sure the edges are straight.
PAPER OUT Paper light on No paper is loaded.
Paper ran out.
Load paper.
Remove any printouts or paper remaining in the printer
and load more paper.
If the message appears during a print job, reset the
printer by pressing the Pause button for 3 seconds.
Then load paper and resend the job.
REAR COVER OPEN — The rear cover has been removed. Replace the rear cover.
RELEASE LEVER REMOVE
PAPER JAM
Paper light
flashing
Paper has jammed in the printer. Remove the jammed paper. See the Printer Basics
book for more information.
RELOAD PAPER Paper light on Printer cannot detect paper.
PAPER NOT CUT error was cleared.
If you are using cut sheets, make sure the paper is flat.
Move the paper lever.
Reload paper.
RELOAD PAPER INSERT
DEEPLY
Paper light on Manually loaded sheet is not inserted
far enough.
Insert the sheet further into the printer.
REMOVE PAPER Paper light on Paper is too thick for head cleaning.
Printer could not feed the printed
page.
Pull the paper lever out to remove the paper. Head
cleaning automatically starts. After cleaning, reload
paper.
Remove the print.
REPLACE CNVRSION CRTG — The conversion cartridge needs to be
replaced.
Replace the conversion cartridge with a new one. Or,
complete the replacement of the black ink by pressing
the
Pause button.
SERVICE REQ. All lights flashing The print head is locked.
An error has occurred.
Pull out the green tab to unlock the print head.
Note the error number, then turn the printer off and
back on. If the message remains, contact Epson.
SET INK CRTG — Ink cartridge chip error. Remove and reinstall the ink cartridge. If the message
remains, replace the cartridge.
SET PAPER LEVER
Paper light on Paper lever was released during the
printing process or another operation.
Pull the lever all the way forward, to the secured
position. Start printing again from the beginning for
best results.
TOP COVER OPEN — Top cover is open. Close the top cover.
Message/Light Light Explanation Response
To Next Page
Loading...
