Epson Stylus Pro 4800 - Updating Your Printer Firmware

Epson Stylus Pro 4800
8/05 Epson Stylus Pro 4800 - 13
Installing the New Black Ink Cartridge
1. When draining is complete, RAISE THE LEFT INK LEVER
appears on the LCD. Raise the ink lever on the left ink
compartment.
2. When
REMOVE CNVRSION CRTG appears, remove the
conversion cartridges from the slots on the left ink
compartment.
3. When
INSERT INK CRTG appears, insert the cartridges in
their specified slots.
4. When
LOWER BOTH INK LEVERS appears, lower the ink
levers on the right and left ink compartments.
5. When
RAISE BOTH INK LEVERS appears, raise the ink
lever on the right and left ink compartments.
The printer starts charging ink. After a while, ink lever
messages appear on the LCD.
Note:
Because ink charging after black ink conversion consumes a
large quantity of ink, you may need to replace the ink cartridges
soon.
6. When a message appears on the LCD, raise or lower the ink
levers accordingly until
READY appears on the LCD.
When
READY appears on the LCD, ink charging is
complete.
7. If you have installed 110 ml ink cartridges, close the ink
compartment covers. If you have installed 220 ml ink
cartridges, do not close the ink compartment covers.
Updating the Printer Driver Information
After the replacement operation, update the driver
information using the steps below.
❏ Mac OS X
Open the Epson Printer Utility in your Applications folder.
Select
Stylus Pro 4800, and click OK. Click the EPSON
StatusMonitor
button and make sure the Matte Black
cartridge option is shown. If not, click
Update.
❏ Windows
Click the
Main tab and make sure that the correct ink
cartridge is displayed. If not, set the information manually
by clicking the
Utility tab and then the Printer and Option
Information
button.
Updating Your Printer Firmware
Before you begin using your printer, you should check for a
newer version of firmware on the Epson support site and
update your printer, if necessary.
Downloading the Firmware
1. Navigate to http://www.support.epson.com in your
browser.
2. Choose your printer.
3. Click
Drivers and Downloads to find the newest
firmware.
4. Choose the version for Macintosh or Windows and follow
the instructions on the screen, then continue in the
appropriate section below to upgrade the firmware.
Updating with Macintosh
1. Double-click the firmware file to extract it.
2. Open the
Applications folder, open the Utilities folder
and then open the
Printer Setup Utility.
3. Highlight
Stylus Pro 4800 in the Printer List, then click
the
Utility button.
4. Click the
EPSON LFP Remote Panel button.
Note:
If the button is grayed out, the LFP Remote Panel is not
installed. See the Printer Guide to install it.