Epson Stylus Pro 4800
12 - Epson Stylus Pro 4800 8/05
2. If you are using 220 ml ink cartridges, remove the four
cartridges from the right ink compartment, then close the
compartment cover.
3. Place your hand under the right ink compartment and
gently pull out the maintenance tank.
Caution:
Be careful not to spill ink from the maintenance tank when
removing it. Hold it upright at all times and dispose of it carefully.
4. Place the used tank in the plastic bag included with the new
tank.
5. Insert the new tank.
6. If you removed any ink cartridges, replace them after
inserting the new maintenance tank.
Changing the Black Ink Cartridge
You can change the black ink from Matte Black to Photo
Black or vice-versa. You will need to use the Black Ink
Conversion Kit (included with your printer) and a new black
ink cartridge (either Matte or Photo that you want to convert
to).
Caution:
To avoid interruption, observe the following conditions: Do not turn
off the printer, open the top cover, remove the rear cover, move
the paper lever to the released position, remove the ink cartridges,
remove the maintenance tank, or unplug the power cord.
Note:
If an electrical power failure occurs during this operation, turn the
printer on again. You can continue your procedure at the breakpoint.
The Photo Black cartridge is ideal for printing photographic
images on all media types. It is optimized for traditional
photographic and ink jet-coated papers, such as Epson
Premium Luster Photo Paper, Photo Semigloss Paper,
Premium Semimatte Photo Paper, etc.
The Matte Black cartridge is optimized for printing
photographic images on matte or plain papers, such as Epson
Enhanced Matte Paper and Epson Velvet Fine Art Paper.
Generally, you should switch black ink cartridges only if you
plan to run a large number of print jobs in the new mode.
Since it takes about several minutes to switch and consumes
some ink, you shouldn’t switch cartridges more often than
necessary.
If
MNT TNK FULL appears on the LCD, you need to replace
the maintenance tank. See page 11.
Draining the Old Ink
1. Make sure that READY appears on the LCD panel.
2. Press the
Menu button.
3. Press the button until you see
MAINTENANCE, and
then press the
Menu button.
4. Press the button until you see
BK INK CHANGE, and
then press the
Menu button.
5. Press the
Menu button again.
6. When
RAISE THE RIGHT INK LEVER appears on the
LCD, raise the ink lever on the right ink compartment.
7. When
RAISE THE LEFT INK LEVER appears on the LCD,
raise the ink lever on the left ink compartment.
8. When
REMOVE INK CRTG appears, remove all four ink
cartridges from the left ink compartment.
9. When
INSTALL CNVRSION CRTG appears, insert the
three conversion cartridges in the slots on the left ink
compartment.
Note:
If REPLACE CNVRSION CRTG appears, press the Pause
button. Remove the old conversion cartridge(s) from the left ink
compartment, and then insert the new conversion cartridge(s).
Go to step 4 to start again.
10. When LOWER THE LEFT INK LEVER appears on the
LCD, lower the ink lever on the left ink compartment.
The printer starts draining ink and
DRAINING XX%
appears on the LCD. Wait until draining is complete.
To Next Page
Loading...
