2-11
Handling Paper | 2-11
9. To help paper feed out of the printer, pull out the two paper guides at
the bottom of the printer.
You can now send your print job.
Cutting Roll Paper Manually
When you’re not using the Auto Cut setting, you need to cut the paper
manually after your print job is finished. Follow these steps:
1. If the paper is not positioned correctly, press one of the
Paper Feed
buttons to adjust the paper position. Normally, you don’t need to do
this after a print job is finished.
2. Press the
Paper Source
button until the
Roll Auto Cut
light comes on.
3. Press the
Cut/Eject
button. The paper is cut.
To Next Page
Loading...
