182
Using the Auto Cut setting
When you want the roll paper to be cut automatically after your
print job, use the Auto Cut setting. To make the Auto Cut setting
using the Paper Source button on the control panel, see
“Buttons”. To use the printer software, see “Auto Cut” for
Windows, and “Auto Cut” for Macintosh.
Note:
When the printer cuts the paper, first the left part of the paper is cut,
then the right, and finally the center. Never turn off the printer before
the paper is cut completely.
Cutting the roll paper manually
To cut the roll paper when the Auto Cut setting is off, follow the
steps below.
Cutting after the document is printed
1. Make sure the document is printed, then press the Paper
Source button repeatedly until the Roll Auto Cut light is on.
2. Press the Cut/Eject button. The roll paper is cut.
Cutting the roll paper at other times
1. Press the to position the paper in place for cutting.
2. Press the Paper Source button repeatedly until the Roll Auto
Cut light is on.
3. Press the Cut/Eject button. The roll paper is cut.
To Next Page
Loading...
