79
Note:
❏
✽
is factory set value.
❏ PARALLEL I/F, IEEE 1284.4, DEFAULT PANEL,
CRTG INFO MENU, and SSCL are for maintenance service
person only.
HEX DUMP
Data received from the host can be printed out in hexadecimal
numbers.
1. Load paper into the printer.
2. HEX DUMP is displayed as the first item in maintenance mode.
Press the SelecType (
r) button to display PRINT.
3. Press the Enter button.
The print data in the print buffer is printed with 16-byte hex.
data in the left column, and corresponding ASCII characters
in the right column.
Note:
❏ If the last data is less than 16 bytes, it is not printed until you
press the Pause button.
❏ To return to maintenance mode while an item is displayed, press
the Paper Source (
l) button.
LANGUAGE
You can select the language to be displayed on the LCD.
1. In maintenance mode, press the Paper Feed (
u) or Paper
Feed (
d) button to select LANGUAGE.
To Next Page
Loading...
