62
NO MARGIN
The following settings can be made.
CUTTER ADJ
Adjusts the paper cutting position when printing with a top and
bottom margin of zero. This function prints cutter adjustment
patterns and you can select the appropriate cutting position from
among them.
REFRESH MRGN
When ON is selected, the printer cuts extra print area after No
Margin printing is used automatically. The cut length depends on
the preset value of the CUT PIECE ADJ mode.
INIT SETTINGS
Sets all setting values you have made to their factory value.
Setting Margin Cut method
1 CUT Sets four sides to
a margin of zero.
Before printing starts, the printer feeds the
paper for the preset length and cuts it
while printing.
After printing starts, the printer does not use
a margin, prints jobs continuously, and cuts
the paper at the border.
2 CUTS Sets four sides to
a margin of zero.
The printer feeds the paper for the preset
length and cuts it while printing.
When the job is finished, the printer cuts the
image at the bottom.
Then, the printer feeds the paper for the
preset length to cut the extra printed area.
Therefore, the printed image is shorter than
the original data by 2mm.
L/R
ONLY
Makes left and
right margin
zero.
-
To Next Page
Loading...
