75
15. Press the Paper Source (
l) button and then the Paper Feed
(
d) button to display SUCTION. Press the SelecType button
(
r) and Paper Feed (
u) or Paper Feed (
d) button to select
either NORMAL or LOW, then the Enter button.
When you use a thin paper, select LOW.
16. Press the Paper Source (
l) button and then the Paper Feed
(
d) button to display PRINT ADJ. Press the SelecType button
(
r) and Paper Feed (
u) or Paper Feed (
d) button to adjust
Microweave, then the Enter button. The setting range is 1 to
5. Increase the value to give priority to the printing speed.
Decrease it to give priority to the print quality.
17. Press the Pause button to exit the SelecType mode.
Selecting the registered settings
To select the registered settings, follow the steps below.
1. In SelecType mode, press Paper Feed (
u) or Paper Feed
(
d) button until PAPER CONFIG is displayed on the LCD panel,
and press SelecType button again.
2. Press Paper Feed (
u) or Paper Feed (
d) button to display
PAPER NUMBER, and press the SelecType button.
3. Press the Paper Feed (
u) or Paper Feed (
d) button to select
the number registered that you want to use. Then press the
Enter button.
4. Press the Pause button to exit the SelecType mode.
To Next Page
Loading...
