6. Adjust until the conditions are true for each of the 4 gauges.
0 direction
Left digit
Right digit
1 direction
1. Insert the 4 gauges and check that the 4 conditions listed above are true.
2. If the conditions listed are not true, loosen the fastening screws, and move the sensor
positions until they are true.
00 = When the 0.4mm thickness gauge is inserted.
10 = When the 0.5mm thickness gauge is inserted.
10 = When the 0.8mm thickness gauge is inserted.
11 = When the 0.9mm thickness gauge is inserted.
01 = When the Pinch Roller Release Mechanism is open.
To Next Page
Loading...
