Epson Stylus Scan 2000 - ENERGY STAR Compliance; Symbols Used in the Manual; System Requirements; For Pcs

6
ENERGY STAR Compliance
■ When choosing a place for the Stylus Scan
■ Place the EPSON Stylus Scan on a flat, stable surface that extends beyond the
Stylus Scan base in all directions. The Stylus Scan will not operate properly if it
is tilted or at an angle.
■ Avoid places subject to rapid changes in temperature and humidity. Also, keep the
Stylus Scan away from direct sunlight, strong light, and heat sources.
■ Avoid places subject to shocks and vibrations.
■ Leave enough room around the Stylus Scan to allow for sufficient ventilation.
■ Place the Stylus Scan near a wall outlet where the plug can be easily unplugged.
■ ENERGY STAR Compliance
As an ENERGY STAR Partner, EPSON has determined that this
product meets the
ENERGY STAR guidelines for energy effi-
ciency.
The International
ENERGY STAR Office Equipment Program is
a voluntary partnership with the computer and office equipment
industry to promote the introduction of energy-efficient personal
computers, monitors, printers, fax machines, and copiers in an effort to reduce air
pollution caused by power generation.
■ Symbols Used in the Manual
w
Warnings
must be followed carefully to avoid bodily injury.
c
Cautions
must be observed to avoid damage to your equipment.
Note:
contain important information and useful tips on the operation of your Stylus Scan.
■ System Requirements
❚ For PCs
To use your EPSON Stylus Scan, you need Microsoft
®
Windows
®
95, or
Windows
®
98; a CD-ROM drive and a shielded, twisted-pair parallel cable. If you want
to connect your device to a USB port, you need a Windows 98 pre-installed PC equipped
with a USB port; and a shielded USB cable.