19
Checking the Stylus Scan
English
■ Checking the Stylus Scan
Before using your EPSON Stylus Scan, make sure it is working correctly by printing
a nozzle check pattern. You may also need to clean the print head.
❚ Loading Paper
Follow the steps below to load A4 size plain paper in the sheet feeder. The Stylus Scan
prints onto this paper when printing and making copies.
1. Lower the output tray and slide out the extension. Next, slide the paper edge guide
to adjust the width of the loading area so that it is slightly wider than the width of
your paper.
2. Fan a stack of paper; then tap it on a flat surface to even the edges.
3. Load the stack of paper with the printable side up and the right edge of the paper
resting against the right side of the sheet feeder. Then slide the edge guide against
the edge of the paper.
Note:
❏ Always load paper into the sheet feeder short edge first.
❏ Make sure the paper stack fits under the arrow mark inside the edge guide.
❚ Printing the Nozzle Check Pattern
Follow the on-screen instructions to check the print-head nozzles. If you do not see any
on-screen instructions, follow these instructions.
paper edge guide
output tray
printable side up
To Next Page
Loading...
