3.
Insert a stack of paper all the way into the paper feeder with
the printable surface facedown. Align the right edge of the
stack with the right edge of the paper feeder. Then move
the left edge guide to match the width of your paper, as
shown below.
4.
Close the paper feeder cover and lower the paper separator
to secure the paper stack.
Now you are ready to run the self test. For more about printing
with the paper feeder, be sure to read “Tips for Using the Paper
Feeder” at the end of this chapter.
1-14
Setting
Up Your
Printer
To Next Page
Loading...
