Power supply
The printer does not work and
control
panel lights are off.
Check that the power cord is properly plugged into the
electrical outlet.
Check that the side of the power switch with the vertical bar
(
I)
is pressed down to turn on the printer.
If the electrical outlet is controlled by an outside switch or
automatic timer, use a different outlet.
Plug another electrical device into the outlet to determine
whether it is working.
The lights come on briefly but then go off and stay off.
Check that the printer’s voltage rating matches the voltage of
your electrical outlet. If the voltages do not match, unplug the
printer and contact your dealer immediately. Do not reconnect
the power cord to an electrical outlet.
Prin
fing
All lights flash but nothing prints.
Contact your dealer.
Printing stops and the
Data
and
Pause
lights flash.
The paper is jammed inside the printer. Follow the steps on
page
3-13.
A carriage error has occurred. Turn off the printer.
After a few seconds,
turn it back on again.
Maintenance
and
Troubleshooting
3-7
To Next Page
Loading...
