4.
Lift the cartridge out of the printer and dispose of it properly.
Do not take the the used cartridge apart or try to refill it.
Cm4
tion:
Ifink
does get on your hands, wash them thoroughly with
soap and water.
If
ink gets into your eyes, flush them
immediately with water.
5.
Turn to page
1-11
and follow the steps there to install the new
cartridge.
Note:
When you replace the cartridge, the printer will not recharge the
ink
delivery system again. However, the print head may start moving as
the printer performs normal maintenance procedures. This can take
up to
40
seconds to complete.
Cleaning
the
Print
Head
If print quality diminishes, use the printer’s built-in print-head
cleaning cycle to ensure that the nozzles are delivering ink
properly. To avoid wasting ink, clean the print head only if
print quality declines.
Follow these steps:
1.
Make sure the printer is turned on and the Pause light is on.
If the Pause light is not on, press the Pause button to
pause the printer.
2.
Hold down the
Alt
button
.and
press the Pause button for
two seconds. The cleaning cycle takes about
40
seconds.
The Pause light flashes throughout the cycle and then
stays on when the cleaning cycle is finished.
3.
Press the Pa use button to resume printing.
Maintenance and Troubleshooting
3-3
To Next Page
Loading...
