For example, if you want to change the loading position
setting, press the
Alt
button
until
the Data light flashes and
the Paper Out light is off.
If you are changing the character-table setting, skip to
“Changing the character-table setting” below.
5;
Press the Font button until the Font lights match your
desired setting as shown in the table below.
Network
Interfacemode
On 0 Off
0
6.
Repeat steps 4 and 5 to make all your changes.
7.
Exit the default setting mode by turning the printer off.
Using Other Printer Functions 2-15
To Next Page
Loading...
