Light status Condition/solution
The left side of the network The wireless LAN is active.
light is on
The right side of the network The Ethernet connection is active.
light is on
The product is receiving data or printing while connected to an Ethernet
The power light is flashing
or wireless network.
The left side of the network
light is flashing
The right side of the network One of the following has occurred:
light is flashing
• An error occurred during WPS network setup. Make sure the router is
in setup mode and is not too far away (less than 10 feet [3 meters]).
Another wireless device may be trying to connect using WPS. Wait a
few minutes and try again.
• You tried to connect to a wireless network while the product was
connected to an Ethernet connection. Disconnect the Ethernet
connection before setting up a wireless connection.
Both sides of the network light You are entering a WPS PIN code or firmware is being updated.
are flashing at the same time
Both sides of the network light WPS network setup is in progress or the product is starting up.
are flashing alternately
The ink light is on An ink cartridge is expended, not installed, not detected, or not
compatible with your product. Install or replace the ink cartridge.
The ink light is flashing One of the ink cartridges is running low. Prepare a new ink cartridge.
One of the following has occurred:
The paper/cancel light is
on
• Paper or a CD/DVD is not loaded
• The CD/DVD tray is not loaded in the product correctly
• Multiple sheets of paper fed at the same time
• Roll paper has run out. Load a new paper roll.
Insert the paper or tray correctly and press the paper/cancel button.
124
To Next Page
Loading...
