139
23. Select and hold Forward on the control panel to feed the roll paper about one revolution of the take-
up roll core.
24. Press and hold the Manual take-up button to wind the roll paper once around the roll core.
25. Make sure that there is some slack in the media and that it loads evenly on both sides.
Note: The media will not take up correctly if it is looser on one side than the other.
26. Select Complete when you are finished.
Parent topic: About Auto Take-up (Dual Roll Models Only)
Removing the Auto Take-up Media
Follow these steps to remove the printed take-up media.
1. Select > Paper Setting > Roll 2 > Feed/Cut Paper and adjust the cutting position.
To Next Page
Loading...
