Epson TM-m50II - Printing Specifications

102
Appendix
Printing Specifications
dpi: dots per inch
*1: Initial setting
*2: When the printer prints with the standard print density level at 25°C {77°F} and 24V.
*3: The maximum is 100 mm/s {3.94"/s} when printing ladder barcodes, 2-dimensional symbols, or multi-tone graphics.
Paper width
58 mm
Paper width
80 mm
Printing method Thermal line printing
Dot density 180 × 180 dpi
Printing
width
42/30 column mode
(Standard column mode)
50.8 ± 0.2 mm
{2.00 ± 0.01"}, 360 dots
72.2 ± 0.2 mm
{2.84 ± 0.01"}, 512 dots
48/36 column mode 50.8 ± 0.2 mm
{2.00 ± 0.01"}, 360 dots
67.7 ± 0.2 mm
{2.67 ± 0.01"}, 480 dots
The number
of characters
42/30 column mode
(Standard column mode)
Font A 30 42
*1
Font B 40
*1
56
Special Font A 30 42
Special Font B 40 56
Kanji Font A 15
*1
21
*1
Kanji Font B 22 32
48/36 column mode Font A 36 48
Font B 40 53
Special Font A 30 40
Special Font B 40 53
Kanji Font A 15 20
Kanji Font B 22 30
Line spacing 4.23 mm {0.17"}
(initial setting, programmable by command)
Maximum print speed
*2
500 mm/s {19.7"/s}
*3
Multi-tone graphics printing Up to 16 shades of gray
(when printed on Epson specified paper)
•
The print speed changes automatically depending on the applied voltage and head temperature.
• If the data transmission speed is slower than the maximum print speed, the print speed may
fluctuate and the print result may become shaded and/or dot displacement in paper feeding
may occur. Furthermore, if the data transmission speed is much slower than the maximum print
speed, intermittent printing will occur.