Epson TM-m50II - Compatibility with USB-A

133
Appendix
Compatibility with USB-A
Devices can be connected to the USB-A connector of the TM-m50II in the following ways.
• Any USB conversion connectors and USB extension cables other than those above cannot be used.
• For (f ), the barcode scanner must have a minimum operable voltage of 4.5 V or less.
• Barcode scanners with USB-HID interface or with CDC-ACM interface can be used.
• To use a barcode scanner, set the scanner suffix (delimiter) to CR (carriage return code). Data
cannot be obtained using any other settings.
• Epson ePOS SDK version 2.9.0 or later supports barcode scanner control.
Secondary connectionDirect connectionTM-m50II
Extension cable of
OT-WL06
Barcode scanner
DM-D30/DM-D70
DM-D30
DM-D30
Optional extension
cable OT-UL30
Wireless LAN unit of
OT-WL06
OT-WL06
OT-WL06
DM-D30
(f)
(a)
(b)
(c)
(d)
(e)
(g)