Epson TM-m50II - Page 56

56
Chapter 3 Advanced Usage
• 57600 bps
• 115200 bps (initial setting)
Serial Interface Parity
• None (initial setting)
• Odd
• Even
Serial Interface Handshaking
• DTR/DSR (initial setting)
• XON/XOFF
Serial Interface Data Bits
• 7 bits
• 8 bits (initial setting)
USB Interface Settings
Class
• USB vendor-defined class
• USB printer class (initial setting)
IEEE1284 Device ID
• Do not output IEEE1284 Device ID
• Output IEEE1284 Device ID (initial setting)
USB power-saving function
• Enable
• Disable (initial setting)
Interface switch waiting time
Select the number of seconds from 1 to 10 in increments of 1 second, or 60 seconds.
Initial setting: 10 seconds
• The Class setting is applied only to the USB-B connector.
• The USB power-saving function is enabled in the following cases.
* The USB power-saving function of the printer is enabled.
* The class is set to vendor-defined class.
* The system allows the USB driver to support the USB power-saving function.