Epson TM-T88

1-12 Setting Up the Printer
Adjustments and Settings
The TM-T88/T88P is set up at the factory to be appropriate for
almost all users. It does, however, offer some settings for users with
special requirements.
It has DIP switches that allow you to change communication
settings, such as handshaking and parity check, as well as print
density.
The TM-T88/T88P also has a near-end sensor for the paper. This
can give you a warning when the paper is almost out. If you find
that there is not enough paper remaining on the roll when the near-
end detector is triggered, you can change the near-end sensor
setting.
See Appendix A if you need to make any of these changes.