Epson TM-T88 User Manual

Dip Switch and Paper Near End Settings A-5
Notes:
•
Changes in DIP switch settings (excluding switch 2-8 interface reset signal) are
recognized only when the printer power is turned on or when the printer is
reset by using the interface. If the DIP switch setting is changed after the
printer power is turned on, the change does not take effect until the printer is
turned on again or is reset.
•
If you turn on DIP switch 2-8 while the printer is turned on, the printer may be
reset, depending on the signal state. DIP switches should not be changed
while the printer power is on.
•
If the print density is set to level 3 or 4, the printing will be at the low speed.

Epson TM-T88 Specifications

General

Print Method	Thermal Line Printing
Resolution	180 dpi
Auto Cutter	Yes
Printer Type	Receipt printer
Interfaces	USB, Serial, Ethernet
Paper Roll Diameter	83 mm
Power Consumption	1.8W (Standby)
Paper Width	80 mm or 58 mm (with paper width guide)
Power Supply	Internal (depending on the model) or External