1–18 Setting Up the Printer
Notes:
Changes in DIP switch settings (excluding switches 2-7 and 2-8)
are recognized only when the printer power is turned on or when the
printer reset by using the interface. If the DIP switch setting is
changed after the printer power is turned on, the change does not
take effect until the printer is turned on again or is reset.
If DIP switch 2-7 or 2-8 is turned on while the printer is turned on,
the printer may be reset, depending on the signal state.
DIP switches should not be changed while the printer power is on.
DIP Switch Set 2
Switch Function ON OFF
2-1
Handshaking (BUSY
condition)
Receive buffer full
Off line or receive
buffer full
2-2 Not defined — —
2-3
Select number of
characters per line
(CPL)
7 × 9 font/9 × 9 font
42CPL/35CPL 40CPL/33CPL
2-4, 2-5 Not defined — —
2-6 Internal use — Fixed to Off
2-7
I/F pin 6 reset
signal
Enabled Disabled
2-8
I/F pin 25 reset
signal
Enabled Disabled
To Next Page
Loading...
