Setting Up the Printer 1–19
Parallel Interface (TM-U325PD)
These are the settings for printers equipped with a parallel
interface.
Notes:
Changes in DIP switch settings are recognized only when the
printer power is turned on or when the printer reset by using the
interface. If the DIP switch setting is changed after the printer
power is turned on, the change does not take effect until the printer
is turned on again or is reset.
DIP Switch Set 1
Switch Function ON OFF
1-1 Auto line feed Enabled Disabled
1-2 Receive buffer capacity 45 bytes
4K bytes
1-3~1-8 Not defined — —
DIP Switch Set 2
Switch Function ON OFF
2-1
Handshaking (BUSY
condition)
Receive buffer full
Off line or receive
buffer full
2-2 Not defined — —
2-3
Select number of
characters per line
(CPL)
7 × 9 font/9 × 9 font
42CPL/35CPL 40CPL/33CPL
2-4, 2-5 Not defined — —
2-6 Internal use — Fixed to Off
2-7 Not defined — —
2-8
I/F pin 31 reset
signal
Fixed to On —
To Next Page
Loading...
