Epson WF-2650 - Solving Network Problems

4 Solving Network Problems
■
Always load paper short edge first and make sure the edge guides are against the paper.
■ Make sure the paper does not extend past the end of the cassette.
■ After you load paper, use the control panel to select the paper size and type.
Solving Network Problems
If you have a network problem with your Epson
®
product, check the messages on the
LCD to diagnose the cause of most problems.
You can also check the basic troubleshooting suggestions below. For more in-depth
troubleshooting, see your online User’s Guide or FAQs at epson.com/support (U.S.) or
epson.ca/support (Canada).
■ Try connecting to the wireless router or access point with your computer or another
device to confirm that it is working correctly.
■ Try restarting the router (turn it off and then on), then try to connect to it again.
■ Print a network status sheet from the product’s control panel.
WF-2650: Press if necessary and select
Setup > Network Settings > Network
Status > Print Status Sheet.
Then press u.
WF-2660: Press if necessary and select
Setup > Network Settings > Network
Status > Details > Print Status Sheet
. Then press one of the x buttons.
■ Verify that the network settings are correct and check the signal strength. If it is poor,
try moving the product closer to your router or access point.