The paper loaded in the specified paper source (tttt) does not match the required paper size (sssss).
Replace the loaded paper with the correct size paper and press the OK button to resume printing, or
cancel the print job. To cancel the print job, see “Canceling Printing” on page 110.
If you press the OK button without replacing the paper, the printer will print on the loaded paper even
though it does not match the required size.
Paper Set tttt ssss1 or ssss2
This message appears in the following situations:
- A4/LT Auto Switching in the Setup Menu is set to On
- when printing a job specified as A4 with the printer driver, there is no paper source that is set as A4 or
as LT (alternate size for A4) in the Tray Menu
- when printing a job specified as letter size with the printer driver, there is no paper source that is set as
LT or as A4 (alternate size for LT) in the Tray Menu
To clear this warning message, make sure that A4 or LT is set to the specified paper source (tttt) in the
Tray Menu, load A4 or Letter size paper (ssss1 or ssss2) in the specified paper source (tttt) and
click the OK button, or cancel the print job. To cancel the print job see “Canceling Printing” on
page 110.
Password Changed
The password has been changed successfully.
Paused
The printer is not ready to print. Press the W Pause/Release button or wait for one minute to make
the printer ready.
Photoconductor Needed Soon
This message indicates that the photoconductor unit is near the end of its service life. You can
continue to print until the Replace Photoconductor message appears.
To clear this warning message and continue printing, select Clear All Warnings from the control
panel’s Reset Menu. For instruction about accessing the control panel menus, see “How to access the
control panel menus” on page 61.
Photoconductor Trouble
AL-M300/AL-M400 Series User's Guide
Using the Control Panel 102
To Next Page
Loading...
Need help?
General