Feed Offset2
Adjusts the vertical position in which to star printing. The position moves lower on the sheet as the
value increases. This setting is used when printing the printing on the backside of paper for duplex
printing.
Scan Offset2
Adjusts the horizontal position in which to start printing. The position moves to the right of the sheet
as the value increases. This setting is used when printing on the backside of paper for duplex printing.
FeedOffsetMP, FeedOffsetC1, FeedOffsetC2, FeedOffsetC3 (For AL-M400 Series only),
FeedOffsetC4 (For AL-M400 Series only)
Adjusts the vertical position in which to start printing. The position moves lower on the sheet as the
value increases. This setting is used when feeding the printed paper from the MP tray, C1, C2, C3 or
C4.
ScanOffsetMP, ScanOffsetC1, ScanOffsetC2, ScanOffsetC3 (For AL-M400 Series only),
ScanOffsetC4 (For AL-M400 Series only)
Adjusts the vertical position in which to start printing. The position moves to the right of the sheet as
the value increases. This setting is used when feeding the printed paper from the MP tray, C1, C2, C3 or
C4.
TR Plain1, TR Plain2, TR SemiThk, TR Labels, TR Thick, TR ExtraThck, TR Thick3, TR
Envelope
Adjusts the density or image granularity for the Plain1, Plain2, Semi-Thick, Labels, Thick, ExtraThick,
Thick3, Envelope, Postcard. The setting becomes darker as the value increases.
TEMP Plain1, TEMP Plain2, TEMP SemiThk, TEMP Labels, TEMP Thick, TEMP ExtraThck,
TEMP Thick3,
TEMP Envelope
Adjusts the fixing temperature for the Plain1, Plain2, Semi-Thick, Labels, Thick, ExtraThick, Thick3,
Envelope, Postcard. The setting becomes hotter as the value increases. Note that the curl of printouts
could increase as the value increases.
Highland
AL-M300/AL-M400 Series User's Guide
Using the Control Panel 93
To Next Page
Loading...
Need help?
General