There is a problem with the photoconductor unit. Remove the photoconductor unit and reinsert it. If
that fails to clear the error, replace the photoconductor unit with a new one. For details about
replacement, see the instructions that come with the photoconductor unit.
Please Wait
Printing cannot start because the previous job is being processed. Try again after a few seconds.
Print Overrun
The required time to process the print data exceeded the print engine speed because the current page is
too complex. Press the OK button to resume printing, or cancel the print job. To cancel the print job,
see “Canceling Printing” on page 109. If this message appears again, select On as the Page Protect
setting in the control panel’s Setup Menu or select Avoid Page Error on the printer driver.
If you continue to receive this message when printing a particular page, try simplifying the page by
limiting the number of graphics or reducing the number and size of fonts.
To avoid this error, it is recommended that you set the Page Protect setting to On and add more
memory to the printer. See “Setup Menu” on page 69 and “Memory Module” on page 116 for details.
PS3 CompactFlash Full (For AL-M400 Series only)
The memory allocated for writing PostScript 3 commands on the optional CompactFlash memory is
full. To clear this warning message, select Clear Warning from the control panel’s Reset Menu. For
instruction about accessing the control panel menus, see “How to access the control panel menus” on
page 60.
RAM CHECK
The printer is checking the RAM.
Ready
The printer is ready to receive data and print.
Reboot to apply settings
You selected No when Do you want to reboot to apply the settings? was displayed. To
clear this warning message, select Clear Warning from the control panel’s Reset Menu. See “How to
access the control panel menus” on page 60 for instructions.
Remove paper from output tray (For AL-M400 Series only)
AL-M300/AL-M400 Series User's Guide
Using the Control Panel 102