The output tray reached the maximum capacity. Removing the printouts will print the rest of the print
job.
Replace Feed Roller C1, Replace Feed Roller C2, Replace Feed Roller C3 (For AL-M400 Series
only), Replace Feed Roller C4 (For AL-M400 Series only)
The feed roller C1, C2, C3, or C4 has reached the end of its service life and needs to be replaced. If this
error occurs, consult your dealer.
Replace Fuser (For AL-M300 Series only)
The fuser has reached the end of its service life and needs to be replaced. For details about replacement,
see the instructions that come with the fuser unit.
!
Caution:
If the printer has been in use, the fuser and the surrounding areas may be very hot. If you must
touch one of these areas, turn off the printer and wait 40 minutes to allow the heat to subside before
doing so.
Replace Maintenance Unit (For AL-M400 Series only)
The maintenance unit has reached the end of its service life and needs to be replaced. For details about
replacement, see the instructions that come with the maintenance unit.
!
Caution:
If the printer has been in use, the fuser and the surrounding areas may be very hot. If you must
touch one of these areas, turn off the printer and wait 40 minutes to allow the heat to subside before
doing so.
Replace Photoconductor
The photoconductor unit has reached the end of its service life and needs to be replaced. For details
about replacement, see the instructions that come with the photoconductor unit.
Replace Toner Cartridge
The toner cartridge has reached the end of its service life and needs to be replaced. For details about
replacement, see the instructions that come with the toner cartridge.
Reserve Job Canceled
AL-M300/AL-M400 Series User's Guide
Using the Control Panel 103
To Next Page
Loading...
Need help?
General
Weight and Dimensions
