Cooling Down
The printer is cooling down. This is not an error message, and will clear itself.
Correct time using Time Setting
The current time setting is reset because you did not connect the power cord for a long time. To clear
this warning message, select Time Setting from Clock Menu and specify the current date and time.
Duplex Memory Overflow
There is not enough memory for duplex printing. The printer prints only on the front and ejects the
paper. To clear this error, follow the instructions below.
If Off is selected as the Auto Cont setting on the control panel’s Setup Menu, press the OK button to
print on the back of the next sheet, or cancel the print job. To cancel the print job, see “Canceling
Printing” on page 109.
If On is selected as the Auto Cont setting on the control panel’s Setup Menu, printing continues
automatically after a certain period of time.
Feed Roller C1 Needed Soon, Feed Roller C2 Needed Soon, Feed Roller C3 Needed Soon (For
AL-M400 Series only), Feed Roller C4 Needed Soon (For AL-M400 Series only)
This message indicates that the feed roller C1, C2, C3, or C4 is near the end of its service life. You can
continue to print until the Replace Feed Roller C1, Replace Feed Roller C2, Replace Feed
Roller C3, or Replace Feed Roller C4 message appears.
To clear this warning message and continue printing, select Clear All Warnings from the control
panel’s Reset Menu. For instruction about accessing the control panel menus, see “How to access the
control panel menus” on page 60.
Form Feed
The printer is ejecting paper due to a user request. This message appears when pressing the Pause/
Release button once, then holding down the OK button for more than 2 seconds in order not to
receive form feed command.
Format Required (For AL-M400 Series only)
AL-M300/AL-M400 Series User's Guide
Using the Control Panel 97
To Next Page
Loading...
Need help?
General
Weight and Dimensions
