The installed CompactFlash memory needs to be formatted to use it with the printer. Select Yes to
format the memory, or select No to cancel formatting. If you select No, CompactFlash Error is
displayed and you cannot use the memory for the printer. In that case, turn off the printer and remove
the CompactFlash memory.
Formatting CF (For AL-M400 Series only)
The CompactFlash memory is being formatted.
Fuser Needed Soon (For AL-M300 Series only)
This message indicates that the fuser unit is near the end of its service life. You can continue to print
until the Replace Fuser message appears.
To clear this warning message and continue printing, select Clear All Warnings from the control
panel’s Reset Menu. For instruction about accessing the control panel menus, see “How to access the
control panel menus” on page 60.
Image Optimum
There is insufficient memory to print the page at the specified print quality. The printer automatically
lowers the print quality so that it can continue printing. If the quality of the printout is not acceptable,
try simplifying the page by limiting the number of graphics or reducing the number and size of fonts.
To clear this warning message, select Clear Warning from the control panel’s Reset Menu. See
“How to access the control panel menus” on page 60 for instructions.
You may need to increase the amount of printer memory to be able to print at the desired print quality
for your document. For more information on adding memory, see “Memory Module” on
page 116.
Install Fuser (For AL-M300 Series only)
The fuser unit is not installed in the printer. Install the fuser unit. For details, see the documentation
supplied with the fuser unit.
!
Caution:
If the printer has been in use, the fuser and the surrounding areas may be very hot. If you must
touch one of these areas, turn off the printer and wait 40 minutes to allow the heat to subside before
doing so.
Install Maintenance Unit (For AL-M400 Series only)
AL-M300/AL-M400 Series User's Guide
Using the Control Panel 98
To Next Page
Loading...
Need help?
General
Weight and Dimensions
