3. DEBRIS COLLECTION BAG
The Debris Collection Bag should be attached at
the debris extraction port.
1. Slide the frame of the collection bag on to the
outlet of the extraction port, ensuring that it is
rmly connected. (Fig 7)
2. To release the bag, slide the frame in the
opposite direction.
Note: To ensure optimal dust collection, empty the
dust bag when it becomes approximately 2/3
full.
4. CHARGING A BATTERY PACK PRIOR TO
USE
A Battery Pack must be inserted into the tool as
detailed below. It is important that the Battery
Pack is of the designated type recommended
for this machine.
Newly purchased Battery Packs do not come fully
charged, and should be charged before use.
Note: Battery power and performance will improve
after several discharge/charging cycles have
been completed.
WARNING: The battery pack and battery charger
supplied are specially designed to work
together. Do not attempt to use any other
charger or battery pack with this Erbauer Mitre
Saw.
1. Position the charger on a work bench or similar
in a well ventilated location away from any heat
source and ensure that the charger cannot be
covered by workshop cloths etc.
2. Plug the charger into a suitable power socket.
The red LED will illuminate.
3. Slide the Erbauer 24V battery pack into the
docking port of the charger while squeezing
the buttons located on either side of the battery
casing. The battery will only t in one way
round.
Fig 7
ERBAUER 24V 165MM SINGLE BEVEL MITRE SAW
To Next Page
Loading...
