Apply light machine oil to the machines pivot points
and lower blade operating arm. Avoid excessive oil, to
which sawdust will cling.
Periodically, sawdust may accumulate under the work
table and the base. Use a vacuum cleaner to remove
this sawdust.
Use a clean, slightly damp cloth to clean the plastic
parts of the machine. Do not use solvents or similar
products which could damage the plastic parts.
WARNING: Do not attempt to clean by inserting pointed
objects through openings in the machines casings etc. The
machines air vents should be cleaned using compressed
dry air.
PLUG REPLACEMENT
The fuse in the main plug of your power tool should always
be replaced with one of identical rating.
Check the voltage given on your power tool matches the
supply voltage.
The power tool is supplied with a tted plug, however if you
should need to t a new plug follows the instruction below.
IMPORTANT
The wire in the mains lead are coloured in accordance with
the following code:
Blue ---Neutral
Brown ---Live
The wire that is coloured blue must be connected to the
terminal that is marked with the letter N. The wire that is
coloured brown must be connected to the terminal that is
marked with the letter L. A 13AMP (BS1363 or BS1363/A)
plug must be used and a 5 AMP fuse must be tted.
A 13AMP (BS1363 or BS1363/A) plug must be used and a 5
AMP fuse must be tted.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed
of with household waste. Please recycle where
facilities exist. Check with your Local Authority or
retailer for recycling advice.
30
ERBAUER 216MM (8”) SLIDING MITRE SAW
ENVIRONMENTAL PROTECTION
Waste electrical products should not be
disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or
retailer for recycling advice.
PLUG REPLACEMENT
The fuse in the main plug of your power tool
should always be replaced with one of
identical rating.
Check the voltage given on your power tool
matches the supply voltage.
The power tool is supplied with a fi tted plug,
however if you should need to fi t a new plug
follows the instruction below.
IMPORTANT
The wire in the mains lead are coloured in
accordance with the following code:
Blue ---Neutral
Brown ---Live
The wire that is coloured blue must be
connected to the terminal that is marked with
the letter N. The wire that is coloured brown
must be connected to the terminal that is
marked with the letter L. A 13AMP (BS1363
or BS1363/A) plug must be used and a 5 AMP
fuse must be fi tted.
A 13AMP (BS1363 or BS1363/A) plug must be
used and a 5 AMP fuse must be fi tted.
To Next Page
Loading...
