4. Firmly slide the battery pack down into the
charger to ensure terminal connection. The
battery locking tabs should positively engage
the charger.
5. Press the button on the top RH side of the
charger just below the LED indicators. The
green LED will illuminate to show that the
battery is fast charging.
6. Remove the battery pack from the charger
when the green LED goes out (approx 1
hour), and store the charger safely for future
use. Remove the battery pack by pressing
the two buttons on either side of the pack and
slide the pack from the charger.
5. INSTALLING OR REMOVING THE BATTERY
PACK
Check that the battery pack is of the designated
type for this machine. We recommend
that the trigger switch is locked in the
OFF position when removing or inserting
the Battery Pack. Refer to OPERATING
INSTRUCTIONS 4.
a. Slide the Battery Pack onto the back of the
machines handle. The Battery can only t one
way round.
b. Firmly slide the Battery Pack fully onto the
tools handle to engage the locking tabs. The
electrical connections inside the handle will
be made automatically.
c. To remove the Battery Pack, simply press
the two locking buttons with your nger and
thumb and slide the Battery Pack from the
handle.
ERBAUER 24V 165MM SINGLE BEVEL MITRE SAW
To Next Page
Loading...
