ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR MITRE SAW
Warning: Be sure to read and understand all instructions. Failure to
follow all instructions listed below may result in electric shock, re and/or
serious personal injury.
1. Know your power tool. Read operator’s manual carefully. Learn the applications and
limitations, as well as the specic potential hazards related to this tool.
2. Always wear safety glasses or eye shields when using this mitre saw. Everyday
eyeglasses have only impact-resistant lenses; they are not safety glasses.
3. Always protect your lungs. Wear a face mask or dust mask if the operation is dusty.
Always use dust extraction equipment to minimise dust.
4. Always protect your hearing. Wear hearing protection during extended periods of
operation.
5. Always inspect the tool cords periodically and if damaged have them repaired.
Always be aware of the cord location.
6. Always check for damaged parts. Before further use of the tool, a guard or other
part that is damaged should be carefully checked to determine if it will operate properly
and perform its intended function. Check for misalignment or binding of moving parts,
breakage of parts, and any other condition that may affect the tool’s operation. A guard
or other part that is damaged should be properly repaired or replaced at a qualied
service centre.
7. Do not abuse the cord. Never use the cord to carry the tools or pull the plug from the
socket. Keep cord away from heat, oil, sharp edges or moving parts. Replace damaged
cords immediately. Damaged cords increase the risk of electric shock.
8. Always make sure that your extension cord is in good condition. When using an
extension cord be sure to use one that is heavy enough to carry the current that your
tool will draw. An undersized cord will cause a drop in line voltage, resulting in loss of
power and overheating.
9. Always inspect and remove all nails from lumber before sawing.
10. Do not use the tool while tired or under the inuence of drugs, alcohol or any
medication. Following this rule will reduce the risk of electric shock, re or serious
personal injury.
11. Save these instructions. Refer to them frequently and use them to instruct others
who may use this tool. If someone borrows this tool, make sure they have these
instructions also.
12. When the correct blade to cut the material has been tted, this saw is
recommended for cutting wood and plastic only.
13. Do not use saw blades with High Speed Steel (HSS) or damaged or deformed
blades.
14. Replace the table insert when worn.
15. Use only saw blades recommended by the manufacturer and which have the
exact bore and diameter required for this machine.
16. Connect your mitre saw to a dust collecting device (I. D.Ø32mm) when sawing.
17. Select saw blades in relation to the material to be cut.
18. Check the maximum depth of cut.
19. When sawing long work pieces, always use extra support to provide better
support, and use clamps or other clamping device
ERBAUER 24V 165MM SINGLE BEVEL MITRE SAW
To Next Page
Loading...
