EASY-ROTOR-CONTROL M V2.2 Instructions
___________________________________________________________________________
© Ing.-Büro E. Alba de Schmidt web : www.schmidt-alba.de
Tannenstr. 16 Page 22 of 44 email : erc@schmidt-alba.de
86836 Untermeitingen / Germany
This document is for the user only. Any publishing (printed or in electronic form) is not allowed.
Start the setup with the file: setup_cpr_x86x64cd_4.3.0.0.exe
You will find a quick-start-guide for CPR in the LANTRONIX-folder on the CD:
Com-Port-Redirector_QS.PDF
By default, the serial speed of the LAN-device is set to 9600 Baud. If you want to use it with a different
speed, as your application doesn’t support 9600 Baud, change the speed settings with the Web-
interface available through the CRP-software.
As the LAN-device only supports 1 configured speed, it cannot be used with the Service-Tool to
- change speed of communication
- perform a firmware-update
These actions are only available through the primary interface (USB, RS232).
To Next Page
Loading...